3D – Three-Dimensional Pressure and Space

A significant problem in the aerospace industry is still that parts required for repairs or the development of space stations must be requested and then brought to the site with a shuttle. It passes valuable time, which often do not have the astronauts when accidents occur. Also, this kind of delivery of spare parts is an extremely cost-consuming process.

3D-Drucktechnik Promises To Help

With the three-dimensional typography remedy could be provided here soon. Thus you would have to equip the space ships and space stations only with a 3-d printer, which can be accessed on an appropriate supply of materials. If necessary, the information needed by the printer can be transmitted by the ground stations. Thus, the required spare part can be made immediately on the spot.

Euronews Hi-Tech: Any Copying Objects With The 3D Printer

This means extremely rapid availability in the event of an emergency, to repair a system to maintain the living conditions required for the people, for example, on board. To significantly reduce the existing space risks to life and limb of the astronauts. Previously they had to wait often weeks or months on deliveries by the ground stations. And the launch of the shuttle shuttle depend not only availability and financing, but also the weather conditions on Earth. These dependencies would completely eliminated when the 3D printing of spare parts.

Another advantage of 3D printing is that the spare parts in the space under the conditions of the vacuum and zero gravity must be far less solid than if they have to survive the harsh conditions of the launch. It is also no longer necessary to send countless variants with a shuttle, so the astronauts can then choose which best fits the three-dimensional pressure of spare parts. The practice tests and the resulting necessary adjustments can be made directly on site.

Comes Faster Than Forecast To The Usage Of 3D Printing?

For the project, to produce spare parts in the 3D-Druck-Verfahren, NASA was looking for are already partners. This is a start up, which is “Made in space”, so “produced in outer space”, the descriptive name. According to current information will concern already putting the finishing touches on the printers, working with various polymer based plastics.

It is likely not long before the start of the practice tests. Insiders take the cautious forecast that full-featured 3D printers already in the year 2014 to the basic equipment of International space station ISS be belong. You also assume that with the new technology the useful life of the ISS significantly can be extended. And they are convinced that it will be also dependent on the further development of this technology, when the first colonies on the Moon or Mars may be established.